Assembly: YFT280 racing drone, NAZE32, Matek Power Distribution Board
A pilot shared his detailed assembly of YFT280 racing drone, NAZE32, Matek Power Distribution Board. Let’s see!
Flight controller: NAZE32
Receiver: FUTABA T6J R2006GS
The pilot soldered main power cable first.
For ESC, he cut off extra length. He left a longer end of two wires to keep vertical.
The pilot installed m3x4+6 nylon bolts.
He installed the power distribution board, motor, and LED strip.
Cut extra length.
When soldering the ESC cable, remember to test the running direction.
Heat the heat-shrink tubes.
4 motors are finished.
Install the landing gear.
Solder the power cable of LED strip.
The pilot also connected 5V BEC power cable and alarm signal wire from power distribution board.
The pilot cut the original pin of the receiver signal cable, and soldered the cable directly on NAZE32.
He cut the extra length of ESC cable and installed new connectors.
He installed the receiver.
The pilot upgraded the firmware before installed battery board.
He installed the antenna on the rear. The final look is well-organized!
Newly assembled racing drone on the flight field.
The pilot shared his drone crash video… A prop is broken.
The kit with power distribution board keeps a low profile and simple appearance. No extra wires!
Article Source: 5imx