A pilot shared his home-made 3-axis gimbal from a 2-axis gimbal. Let’s see!
The pilot had a 2-axis gimbal. He tried to upgrade to a 3-axis.
The pilot got a 3-axis extension board and a motor.
The left pins are connected to YAW motor. The right pins are connected to the controller board.
Install the motor properly by all means.
Go to PC and adjust the setup. Select YAW extension board before activate the 3-axis.
If the YAW axis is tilt, adjust the parameters here.
The pilot used the roll channel to control the motor.
Article Source: 5imx